Bush-hog Estate Series Bedienungsanleitung PDF herunterladen (Seite 19)

MOTION CONTROL STEERING ADJUSTMENT

1. Raise the drive wheels of the Zero Turn

off of the ground. Safely block the frame

in this position so it is secure. This

adjustment must be made with the drive

wheels turning.

2. Remove the electrical connection from

the seat switch and temporarily install a

jumper wire across the terminals of the

wiring harness.

3. Loosen the jamnuts on the hex turnbuckle,

which connects the lever control arm to

the pump control arm. Note: The nuts to

the front of the hex turnbuckle have left-

handed threads.

4. Start the engine. Run the engine at full

throttle and release brake.

5. Position the control levers in the neutral

position. If the drive wheels creep

(rotate) in the neutral position then

lengthen or shorten the turnbuckle

assembly. Make the adjustment to stop

the wheel from rotating.

6. Re-tighten the nuts at the end of the hex

turnbuckles and repeat the procedure for

the opposite side of the unit.

7. Shut the unit off. Remove the jumper wire from

the wiring harness and replace the connectors

into the seat switch. Never operate the mower

unless all safety switches are operating properly.

DRIVE ADJUSTMENTS

Steering and motion controls should be uniform in all

forward and reverse speeds. From the reverse posi-

tion the levers should automatically return to neutral

when released.

TEST DRIVE OPERATIONS

Check air pressure in tires. Equal tire pressure is

critical for proper drive operation.

1. Raise drive wheels off ground. Safely block

the frame in this position.

2. Put control levers in neutral lock position

(control levers swung outward).

3. Start engine. Wheels should not rotate. If one or

both drive wheels are turning, perform proce-

dures under “Motion Control Adjustment” for

side(s) that wheel turns.

CAUTION

STOP THE ENGINE BEFORE MAKING

ADJUSTMENTS.

MOTION CONTROL LEVER ADJUSTMENT

1. There are three lever height positions available.

Place the levers in the position that provides the

most confortable operating position for you.

2. Align the levers front/rear position. With the

levers in the neutral position, loosen the hard-

ware and adjust the levers by tilting forward or

backward until properly aligned. tighten hardware.

Lever Position Adjustment Bolts

Pump

Control Arm

Hex Turnbuckle

Jamnut

Control Arm Lever

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Bush-hog Estate Series Bedienungsanleitung Seite 19

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gartengeräte Bush-hog Estate Series